What is the timeout for a new call? Is it the T302 timer?
Especially, when already in a call, after pushing Transfer, what timer is responsible for determining when to stop waiting for digits, before any digits are dialed.
T302 Timer: Required Field This parameter specifies an interdigit timer for sending the SETUP ACK message. The timer restarts each time Cisco CallManager receives a digit. When this timer expires, Cisco CallManager routes the dialed digits. For exact timer definitions, refer to the Q.931 specification.
Our situation has nothing to do with ISDN and thus Q.931 however. Everything is SIP.
On the other hand, I can understand when you're trying to do a transfer, you first push the Transfer button to have them hear MoH, and then go searching for the number you actually transfer to, it can take more than 15 seconds before you push a button.
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...