Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

newbie question

First let me appologize I'm just getting started in voice and studying on my own. I'm setting up a home lab and I'm trying to get outside pstn service thru my 3640 router. I have an fxs port configured with dial-peer pots but not quite sure how i should hook up my fxo port. when I dial my home phone number i see the fxo port card light and it answers after two rings but then i hear another dial tone. I hope my question is coming accross clearly. I would appreciate your patience and any help .thanks

3 REPLIES
Community Member

Re: newbie question

Hey there, can you post your config so we can take a look?

Cisco Employee

Re: newbie question

ok, you need 2 things there

1 dial peer to your FXS

2 connection plar configured under the voice port to avoid getting the dial tone and sending the call somewhere

so, if you have a dial-peer with destination pattern 1000, under the FXO voice port config you set a connection plar 1000

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
Community Member

Re: newbie question

Thanks for your help Java, that solved it!!

97
Views
0
Helpful
3
Replies
CreatePlease to create content