I am trying to get a CME to work with a DMS-500/CS2K with 2 T1s.
Although the 2 ends are happy when the T1s are configured independently, when configured for NFAS I get timeout errors and flapping between the primary and backup D channels.The CME is running IOS version 12.4(9) and the configuration and console output is shown in the attached file.
I am no ISDN expert and know even less about the DMS-500, so any help or hints would be very much appreciated.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...