11-16-2006 09:01 AM - edited 03-14-2019 06:51 PM
I am trying to configure NFAS with DMS250 but it does not look like that switchtype is supported. Is there an alternate switchtype that is compatible or do I need to have carrier change?
11-16-2006 10:07 AM
Hi Mark,
According to the info I have read, DMS-250 is a supported switchtype. Have a look;
ISDN NFAS Prerequisites
NFAS is only supported with a channelized T1 controller and, as a result, must be ISDN PRI capable. Once the channelized T1controllers are configured for ISDN PRI, only the NFAS primary D channel must be configured; its configuration is distributed to all the members of the associated NFAS group. Any configuration changes made to the primary D channel will be propagated to all NFAS group members. The primary D channel interface is the only interface shown after the configuration is written to memory. The router must connect to either an AT&T 4ESS, Northern Telecom DMS-100 or DMS-250, or National ISDN switch type
ISDN Switch Types and Supported NFAS Types
Lucent 4ESS
Custom NFAS
Northern Telecom DMS-250
Custom NFAS
Northern Telecom DMS-100
Custom NFAS
Lucent 5ESS
Custom (Does not support NFAS)
Lucent 5ESS
NI NFAS
AGCS GTD5
NI NFAS
Other Switch Types
NI NFAS
From this doc;
Hope this helps!
Rob
Please remember to rate helpful posts.....
11-16-2006 12:45 PM
I am trying to change the switchtype on the gateway. THis is all that is availabe:
MTWA-VGWY-TELCO(config)#int s0/0/0:23
MTWA-VGWY-TELCO(config-if)#isd
MTWA-VGWY-TELCO(config-if)#isdn sw
MTWA-VGWY-TELCO(config-if)#isdn switch-type ?
primary-4ess Lucent 4ESS switch type for the U.S.
primary-5ess Lucent 5ESS switch type for the U.S.
primary-dms100 Northern Telecom DMS-100 switch type for the U.S.
primary-net5 NET5 switch type for UK, Europe, Asia and Australia
primary-ni National ISDN Switch type for the U.S.
primary-ni2c The Cisco NAS-SC switchtype based on NI2C.
primary-ntt NTT switch type for Japan
primary-qsig QSIG switch type
DMS-250 is not an option. This is the same for the controller.
is there an option for DMS-250? Thanks!
11-16-2006 01:01 PM
Hmmmmmmmmm, that is odd. Did you try DMS100?
Rob
11-16-2006 04:30 PM
That is what i am going to do. Wondering if there will be any issues.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: