Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NFAS w/DMS250

I am trying to configure NFAS with DMS250 but it does not look like that switchtype is supported. Is there an alternate switchtype that is compatible or do I need to have carrier change?

4 REPLIES
Hall of Fame Super Red

Re: NFAS w/DMS250

Hi Mark,

According to the info I have read, DMS-250 is a supported switchtype. Have a look;

ISDN NFAS Prerequisites

NFAS is only supported with a channelized T1 controller and, as a result, must be ISDN PRI capable. Once the channelized T1controllers are configured for ISDN PRI, only the NFAS primary D channel must be configured; its configuration is distributed to all the members of the associated NFAS group. Any configuration changes made to the primary D channel will be propagated to all NFAS group members. The primary D channel interface is the only interface shown after the configuration is written to memory. The router must connect to either an AT&T 4ESS, Northern Telecom DMS-100 or DMS-250, or National ISDN switch type

ISDN Switch Types and Supported NFAS Types

Lucent 4ESS

Custom NFAS

Northern Telecom DMS-250

Custom NFAS

Northern Telecom DMS-100

Custom NFAS

Lucent 5ESS

Custom (Does not support NFAS)

Lucent 5ESS

NI NFAS

AGCS GTD5

NI NFAS

Other Switch Types

NI NFAS

From this doc;

http://www.cisco.com/en/US/products/sw/iosswrel/ps1831/products_configuration_guide_chapter09186a00800d9843.html#wp1001021

Hope this helps!

Rob

Please remember to rate helpful posts.....

New Member

Re: NFAS w/DMS250

I am trying to change the switchtype on the gateway. THis is all that is availabe:

MTWA-VGWY-TELCO(config)#int s0/0/0:23

MTWA-VGWY-TELCO(config-if)#isd

MTWA-VGWY-TELCO(config-if)#isdn sw

MTWA-VGWY-TELCO(config-if)#isdn switch-type ?

primary-4ess Lucent 4ESS switch type for the U.S.

primary-5ess Lucent 5ESS switch type for the U.S.

primary-dms100 Northern Telecom DMS-100 switch type for the U.S.

primary-net5 NET5 switch type for UK, Europe, Asia and Australia

primary-ni National ISDN Switch type for the U.S.

primary-ni2c The Cisco NAS-SC switchtype based on NI2C.

primary-ntt NTT switch type for Japan

primary-qsig QSIG switch type

DMS-250 is not an option. This is the same for the controller.

is there an option for DMS-250? Thanks!

Hall of Fame Super Red

Re: NFAS w/DMS250

Hmmmmmmmmm, that is odd. Did you try DMS100?

Rob

New Member

Re: NFAS w/DMS250

That is what i am going to do. Wondering if there will be any issues.

626
Views
0
Helpful
4
Replies
CreatePlease login to create content