Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

NIC teaming Call Manager 6.1.2

How is NIC teaming enabled on UCM 6.1 servers. I thought it was via the "set network failover" command but I am not able to get this working

5 REPLIES
New Member

Re: NIC teaming Call Manager 6.1.2

It is indeed. The full command is:

set network failover enable

New Member

Re: NIC teaming Call Manager 6.1.2

Is NIC teaming is supported on Call manager 6.1.2 (IBM platform)

Hall of Fame Super Red

Re: NIC teaming Call Manager 6.1.2

Hi Asim,

NIC Teaming Support

Server platforms with dual Ethernet network interface cards (NICs) can support NIC teaming for network fault tolerance with Cisco Unified Communications Manager. Cisco began support of NIC teaming on HP servers in the 5.0(1) release and began support on IBM servers in the 6.1(2) release. This feature allows a server to be connected to the Ethernet via two NICs and, hence, two cables. NIC teaming prevents network downtime by transferring the workload from the failed port to the working port. NIC teaming cannot be used for load balancing or increasing the interface speed.

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/rel_notes/6_1_2/cucm-rel_note-612.html#wp412614

Hope this helps!

Rob

New Member

Re: NIC teaming Call Manager 6.1.2

Thanks rob,

Can you give me sample configuration for enabling Teaming on cisco Call manager 6.1.2(IBM)

thanks in advance

Re: NIC teaming Call Manager 6.1.2

It's the same command listed above.

572
Views
0
Helpful
5
Replies