Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NIC Teaming MCS 7825-H2 Unified CallManager 5.x

Upto now I couldn't find information about NIC Teaming on a CallManager 5.x platform, except that it is supported.

Is it enabled by default? If not, is there a description available how to enable and how use it?

Thanks,

Eric

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Re: NIC Teaming MCS 7825-H2 Unified CallManager 5.x

eric,

you can do this with ccm cli. have a look at this link:

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00806c3e25.html#wp1011080

"set network failover enable" only NFT.

regards

mehmet

3 REPLIES
Bronze

Re: NIC Teaming MCS 7825-H2 Unified CallManager 5.x

eric,

you can do this with ccm cli. have a look at this link:

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00806c3e25.html#wp1011080

"set network failover enable" only NFT.

regards

mehmet

New Member

Re: NIC Teaming MCS 7825-H2 Unified CallManager 5.x

mehmet

I have upgraded CallManager 5.0.2 to 5.0.4 so I would like to know if I can enable network failover

Regards

Alfredo

Re: NIC Teaming MCS 7825-H2 Unified CallManager 5.x

Alfredo, No difference in the way NFT is done in 5.0 or 5.1. Use the same command "set network failover enable" from CLI.

328
Views
0
Helpful
3
Replies
CreatePlease login to create content