We had a problem, where Night service was still active after 09:00. It has been working for over a year and has the same config.
There was an outage this morning and all the phones were down. Once all the switches etc were restored, the night service problem was apparent. All the DDI's worked. We even tried the access code for switching night service and that made no difference. The time and date was also correct. Then all of a sudden the problem disappeared. What I have been trying to find out. Is there a command on the router to show what state the system is in i.e normal hours or night service? or any troubleshooting commands in case it happens again?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...