Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NM-HD-2V or NM-HDV2

What is the difference between this 2 network Modules??

Can I connect 2 VIC2-2BRI-NT/TE on a NM-HD-2V (using the NM slot) and still have the 4 slots for HWIC, WIC, VIC, or VWIC type modules on a 2821 router??

Thanks

Ricardo

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: NM-HD-2V or NM-HDV2

The precious "voice hardware compatibility matrix" at:

http://cisco.com/en/US/products/hw/routers/ps259/products_tech_note09186a00800e73f6.shtml

says that you can do that.

Hope this helps, please rate post if it does!

2 REPLIES

Re: NM-HD-2V or NM-HDV2

HD-2V has DSPs on board. You cannot add or expand the dsps available using PVDM2s on a HD-2V module. It will take all the VICs and VWICs like the NM-HDV2 ,but no expansion on the DSP side. NM-HDV2 on the other hand is capable of expanding the number of PVDM2 chips. For the same reason you may use it for terminating vics/vwics or use as a dspfarm.

Hall of Fame Super Gold

Re: NM-HD-2V or NM-HDV2

The precious "voice hardware compatibility matrix" at:

http://cisco.com/en/US/products/hw/routers/ps259/products_tech_note09186a00800e73f6.shtml

says that you can do that.

Hope this helps, please rate post if it does!

683
Views
15
Helpful
2
Replies
CreatePlease to create content