A few days ago I inserted a network module NM-HD-2VE in a Cisco 3725 chassis in order to insert two VWIC2-1MFT-E1 cards.
The customer have a CUCM 4.3 and when I tried to configure the endpoint of the second VWIC2 card, CUCM showed a window in which I read: "You are trying to configure a duplicate port for this slot. Please change your VIC selection to correct port numbers"
Is not possible to apply two VWIC cards in this NM? Is really obligatory to insert at least one VIC card?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...