Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

NME-CUSP-522 is unable to load the image

Hi!

During the installation of  the subject, I've got the following issue:

===========================================================

DDR2 Memory 2047 MB with ECC detected

Intel(R) Pentium(R) M processor 1.40GHz

BIOS ISE 6.00, Build date: 08/02/06

System Now Booting ...


<sniped>

Booting from secondary boot loader..., please wait.


[BOOT-ASM]



Please enter '***' to change boot configuration:

Unable to load image

Unable to boot image�


===========================================================

After the output above, the module is reloading (in a cycle).

Any ideas? I suppose there no CUSP image file is on the HDD. Or HDD is broken. Has anyone experienced the same problem?

wbr,

Serg

Everyone's tags (3)
2 REPLIES
New Member

NME-CUSP-522 is unable to load the image

I am experiencing this problem after a power outage.  How did you get past it?

New Member

NME-CUSP-522 is unable to load the image

As I remember, I just booted the system via tftp using helper file. Then I did the clean install.

323
Views
0
Helpful
2
Replies
CreatePlease to create content