Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

No call progress tone with TCL IVR

Hello,

I have faced a problem getting call progress tone with TCL IVR 2 on 2801 gateway with 12.4 IOS. There is PSTN number handled by TCL script which does authentication, collects a number and routes it to UCM 8.6. Everything works well if I call IP phone DN but if I call a number routed to MGCP controlled gateway (2811) I can't hear call progress tone but dialed phone connected to PBX rings. To ensure it is IVR problem I removed application from incoming dial-peer and got CP tone. ISDN traces on treminating 2811 gateway with and without my application on originating 2801 gateway are identical, call flows with PI = 8.

I place the call with the following code:

  set callInfo(guid)         $dest_guids

  set callInfo(incomingGuid) $guid

  set callInfo(accountNum)   $account

  set callInfo(displayInfo) "DISA $account"

  set callInfo(originationNumPI) "presentation_allowed"

  leg setup $destination callInfo

I tried to place "leg progress -p 8" but nothing changed.

Have anybody faced such problem? Where should I look for passing inband CP tones?

Regards,

Maxim

Everyone's tags (2)
321
Views
0
Helpful
0
Replies