Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

NO CallForwardAll when using OverlapSending

Have a 0.X route pattern using OverlapSending. Everything works OK for PSTN calls.

But when trying to CFwdALL to a PSTN destination is impossible, the diverted number is accepted straight away after 2nd digits.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: NO CallForwardAll when using OverlapSending

Hi,

to overcome this, you need to configure an additional route pattern with a wildcard character, such as "0.!" and put this in a separate partition. Create a additional CSS and assign this on the line CallForward-CSS.

http://www.cisco.com/en/US/partner/products/sw/voicesw/ps556/products_configuration_example09186a008012f948.shtml

HTH

regards

mehmet

1 REPLY
Cisco Employee

Re: NO CallForwardAll when using OverlapSending

Hi,

to overcome this, you need to configure an additional route pattern with a wildcard character, such as "0.!" and put this in a separate partition. Create a additional CSS and assign this on the line CallForward-CSS.

http://www.cisco.com/en/US/partner/products/sw/voicesw/ps556/products_configuration_example09186a008012f948.shtml

HTH

regards

mehmet

93
Views
0
Helpful
1
Replies
CreatePlease to create content