Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

No Conference Bridge Error - CME 4.1

Trying to configure meet me conferencing on CME 4.1 2811 box. I have the dsp(s) and have the conference hardware command under telephony service. I also have the e-phone dn setup for my meet me number. When I go off-hook and hit meet me softkey I get dialtone, when I enter the meet me dn I get the error No Conference Bridge. I have been through the admin guide 10 times. Any suggestions from anyone would be appreciated.

9 REPLIES
bc
New Member

Re: No Conference Bridge Error - CME 4.1

Your DSP-Farm is configured and registered?

Maybe try another IOS Version. I had a similar issue with cme and one of the 4.x Versions.

New Member

Re: No Conference Bridge Error - CME 4.1

Yes it is. I will look into another IOS ver.

Thank you.

Re: No Conference Bridge Error - CME 4.1

If you make a 'show dspfarm all' is your CB showing as registered?

Try a no sccp / sccp and check again

New Member

Re: No Conference Bridge Error - CME 4.1

Good call - but that did not work.

Re: No Conference Bridge Error - CME 4.1

Well if it is not registered then indeed you have a problem with your configuration. In a CME you need to have the following check your show run:

sccp local Loopback0

sccp ccm 192.168.102.1 identifier 1 version 4.0

sccp

!

sccp ccm group 1

associate ccm 1 priority 1

associate profile 1 register mtp001c58551650

associate profile 2 register confdsp1

!

dspfarm profile 1 transcode

codec g711ulaw

codec g711alaw

codec g729ar8

codec g729abr8

codec g729br8

codec g729r8

maximum sessions 2

associate application SCCP

!

dspfarm profile 2 conference

codec g711ulaw

codec g711alaw

codec g729ar8

codec g729abr8

codec g729r8

codec g729br8

maximum sessions 2

associate application SCCP

telephony-service

sdspfarm units 5

sdspfarm transcode sessions 5

sdspfarm tag 1 mtp001c58551650

sdspfarm tag 2 confdsp1

-----------------------------

Is really important to have the exact same name on both telephony service and in the associate profile command

New Member

Re: No Conference Bridge Error - CME 4.1

Yep, verified and my configuration looks correct.

Re: No Conference Bridge Error - CME 4.1

Could you please upload your show run?

New Member

Re: No Conference Bridge Error - CME 4.1

Wait a minute, you were right. I had only a partial command in my config. I added sccp ccm 10.107.10.4 identifier 1 version 4.1 and it worked. Thank you!

Re: No Conference Bridge Error - CME 4.1

Great !!! thx for the rating. have a nice day

830
Views
5
Helpful
9
Replies