08-21-2008 06:05 AM - edited 03-15-2019 12:45 PM
Trying to configure meet me conferencing on CME 4.1 2811 box. I have the dsp(s) and have the conference hardware command under telephony service. I also have the e-phone dn setup for my meet me number. When I go off-hook and hit meet me softkey I get dialtone, when I enter the meet me dn I get the error No Conference Bridge. I have been through the admin guide 10 times. Any suggestions from anyone would be appreciated.
08-22-2008 05:53 AM
Your DSP-Farm is configured and registered?
Maybe try another IOS Version. I had a similar issue with cme and one of the 4.x Versions.
08-22-2008 05:54 AM
Yes it is. I will look into another IOS ver.
Thank you.
08-22-2008 06:32 AM
If you make a 'show dspfarm all' is your CB showing as registered?
Try a no sccp / sccp and check again
08-22-2008 06:42 AM
Good call - but that did not work.
08-22-2008 06:47 AM
Well if it is not registered then indeed you have a problem with your configuration. In a CME you need to have the following check your show run:
sccp local Loopback0
sccp ccm 192.168.102.1 identifier 1 version 4.0
sccp
!
sccp ccm group 1
associate ccm 1 priority 1
associate profile 1 register mtp001c58551650
associate profile 2 register confdsp1
!
dspfarm profile 1 transcode
codec g711ulaw
codec g711alaw
codec g729ar8
codec g729abr8
codec g729br8
codec g729r8
maximum sessions 2
associate application SCCP
!
dspfarm profile 2 conference
codec g711ulaw
codec g711alaw
codec g729ar8
codec g729abr8
codec g729r8
codec g729br8
maximum sessions 2
associate application SCCP
telephony-service
sdspfarm units 5
sdspfarm transcode sessions 5
sdspfarm tag 1 mtp001c58551650
sdspfarm tag 2 confdsp1
-----------------------------
Is really important to have the exact same name on both telephony service and in the associate profile command
08-22-2008 06:50 AM
Yep, verified and my configuration looks correct.
08-22-2008 06:53 AM
Could you please upload your show run?
08-22-2008 06:57 AM
Wait a minute, you were right. I had only a partial command in my config. I added sccp ccm 10.107.10.4 identifier 1 version 4.1 and it worked. Thank you!
08-22-2008 06:58 AM
Great !!! thx for the rating. have a nice day
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide