I am trying to configure Hardware based conferencing on a Cisco 2811 ISR which has a PVDM-16 and PVDM-32 installed. I have configured SCCP and the conference profile in the DSPFARM and have entered 'No Shut' on the profile, watched the debugs as the resources get assigned however the conference bridge is still not fully up?? it's current state is: RESOURCE_ALLOCATED however the next line says: Application: SCCP Status: Not Associated?
I have entered the commands to associate the profile to SCCP so im not sure where the problem lies?
This router is running UCME 3.1 and I am configuring through the CLI.
Voice Configuration is below ( i have removed non essential config out):
The Cisco Unified Communications Manager Express (CME) 4.1 Multi-party Conferencing Enhancement adds digital signal processor (DSP) based ad-hoc and meet-me conferencing capabilities to Cisco Unified CME system.
CME hardware conferencing requires 12.4(11)XJ or 12.4(15)T or later IOS and supports both Ad-Hoc and Meet-Me conferencing.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...