Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

No Conference Bridge

I have configured a Cisco Call Manager 5.0 in a Lab with only 3 IP Cisco Phones. They can communicate between them, but I have not been able to configure the conference caracteristic among them. When I intend to make the conference an error message "No conference Bridge" appear in the display.

Can anyone help to me?

Thanks.

Pablo

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Red

Re: No Conference Bridge

Hi Pablo,

You will need to set up a Software Conference Bridge to test these features. Here is how;

Conference Bridges

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00803edae2.html#wp91541

Adding a Software Conference Device

From this doc;

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00803ed6a4.html#wp1023972

Hope this helps!

Rob

3 REPLIES
Hall of Fame Super Red

Re: No Conference Bridge

Hi Pablo,

You will need to set up a Software Conference Bridge to test these features. Here is how;

Conference Bridges

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00803edae2.html#wp91541

Adding a Software Conference Device

From this doc;

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00803ed6a4.html#wp1023972

Hope this helps!

Rob

Cisco Employee

Re: No Conference Bridge

just as a side note to the great info from Rob make sure the phones are talking G711 when testing since the SW CFB cannot handle other codecs

HTH

javalenc

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi

Re: No Conference Bridge

This is the same issue i had some time back. while playing around i confiured g.729 codec for the ip phones and then after few days I was trying to do conferencing which was not working.

Changed the codec back to 711 and things started working.

CallManager when configured as a software conference bridge is capable of supporting 711 conferences only.

-> Sushil

372
Views
0
Helpful
3
Replies