I have a branch office connected to the central office using a PPP link. There is a CCM in the central site (3.3.4 sr2) and ip phones in the branch office.
Using additional DSP on the Gateway of the Remote Office (Cisco1760) I've configured the CFB in the CCM, and then the MRG & MRGL and applied to the Device Pool of that branch office. The CFB is registered to the CCM, and when I run sh dspfarm and sh sccp I see that it's up/active. But when the people of the branch office want to make a conference once the third party is added the call is dropped.
Any ideas?? I'm attaching the running config and a debug at the time of the conference attempt.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...