No dial-tone FXS in cisco 2911

[spinning2008]

Hi all,

I have a lot of problems with cisco 2911 with IOS: c2900-universalk9-mz.SPA.152-4.M5 in FXS port.

I don't have dial tone in FXS port, always busy.

I configured the port as stcapp, Incoming calls works ok,  but there is no dial tone.

I done upgrade downgrade, port is working fine with STACPP in C-881 V (dial tone is ok) but not in cisco 2911.

Any idea?

Regards.

[Hermanus Janse van Vuuren]

Hi;

Try applying:

cptone (followed by country code i.e. GB for the UK) to the analogue voice ports

[Nadeem Ahmed]

Hi,

In addition to above, You need to configure correct "Locale" on CUCM for that endpoint(analog port). This will configure automatically correct cptone value under that analog voice port.

Br,
Nadeem 

Please rate all useful post.

[Carlo Poggiarelli]

Hi.

If you are in a CME setup using STCAPP, verify that you have a dialpeer using service stcapp followed by port X/X/X where FXS is located

HTH

Regards

Carlo

Please rate all helpful posts

"The more you help the more you learn"

[jugalkansal90]

Hi,

I have VG204 (MGCP), I dont have dial tone on all 4 FXS ports. Port 0/0 is configured as POTS and port0/1 as LS. Below is the configuration I have on ports and dial peers.

dial-peer voice 200 pots
 service stcapp
 port 0/1
!
dial-peer voice 201 pots
 service stcapp
 port 0/1
!
dial-peer voice 202 pots
 service stcapp
 port 0/2
!
dial-peer voice 203 pots
 service stcapp
 port 0/3
!
dial-peer voice 9990099 pots
 service mgcpapp
 port 0/0
!
dial-peer voice 9990199 pots
 service mgcpapp
 port 0/1



voice-port 0/0
 timeouts ringing infinity
 caller-id enable
voice-port 0/1
 timeouts ringing infinity
 caller-id enable
voice-port 0/2
 timeouts ringing infinity
 caller-id enable
voice-port 0/3
 timeouts ringing infinity
 caller-id enable

CUCM ver is 11.5, ios is 15.4.