Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

No dial-tone FXS in cisco 2911

Hi all,

I have a lot of problems with cisco 2911 with IOS: c2900-universalk9-mz.SPA.152-4.M5 in FXS port.

I don't have dial tone in FXS port, always busy.

I configured the port as stcapp, Incoming calls works ok,  but there is no dial tone.

I done upgrade downgrade, port is working fine with STACPP in C-881 V (dial tone is ok) but not in cisco 2911.

Any idea?

Regards.

4 REPLIES

No dial-tone FXS in cisco 2911

Hi;

Try applying:

cptone (followed by country code i.e. GB for the UK) to the analogue voice ports

Voice CCIE #37771
Cisco Employee

No dial-tone FXS in cisco 2911

Hi,

In addition to above, You need to configure correct "Locale" on CUCM for that endpoint(analog port). This will configure automatically correct cptone value under that analog voice port.


Br,
Nadeem 

Please rate all useful post.

Br, Nadeem Please rate all useful post.

No dial-tone FXS in cisco 2911

Hi.

If you are in a CME setup using STCAPP, verify that you have a dialpeer using service stcapp followed by port X/X/X where FXS is located

HTH

Regards

Carlo

Please rate all helpful posts

"The more you help the more you learn"

Please rate all helpful posts "The more you help the more you learn"
New Member

Hi,

Hi,

I have VG204 (MGCP), I dont have dial tone on all 4 FXS ports. Port 0/0 is configured as POTS and port0/1 as LS. Below is the configuration I have on ports and dial peers.

dial-peer voice 200 pots
 service stcapp
 port 0/1
!
dial-peer voice 201 pots
 service stcapp
 port 0/1
!
dial-peer voice 202 pots
 service stcapp
 port 0/2
!
dial-peer voice 203 pots
 service stcapp
 port 0/3
!
dial-peer voice 9990099 pots
 service mgcpapp
 port 0/0
!
dial-peer voice 9990199 pots
 service mgcpapp
 port 0/1



voice-port 0/0
 timeouts ringing infinity
 caller-id enable
voice-port 0/1
 timeouts ringing infinity
 caller-id enable
voice-port 0/2
 timeouts ringing infinity
 caller-id enable
voice-port 0/3
 timeouts ringing infinity
 caller-id enable

CUCM ver is 11.5, ios is 15.4.

188
Views
15
Helpful
4
Replies
CreatePlease login to create content