Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

No Dial Tone in Analog Ports

Hi There,

We have configured Analog Ports in VG224 , It showing registered in CUCM, But there is no dial tone in FXS Ports, may i know what could be a problem?

Faxmode is: Fax Relay

Regards,

Bala

4 REPLIES
Hall of Fame Super Silver

No Dial Tone in Analog Ports

So, when you connect analog port and you go off hook you do not hear anything? Sounds like cabling issue.

Are you sure your patching/cabling is correct?  Are you using patch panel/110 block/66 block to extend the ampahol connection?

Chris

New Member

No Dial Tone in Analog Ports

Hi Chris,

Yes, Cabling is fine, We used 2 more VG224 in the same LAN, It worked, This one is new VG224 which is not gving dial tone.

Thanks

Bala

Green

No Dial Tone in Analog Ports

Bala,

If you are sure your wiring set up is good.

Have wee look at this link.

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a00805552e9.shtml

May be a DC voltage level issue

Regards

Alex

Regards, Alex. Please rate useful posts.

No Dial Tone in Analog Ports

Jeya Balasubramani Arumugam wrote:

Yes, Cabling is fine, We used 2 more VG224 in the same LAN, It worked, This one is new VG224 which is not gving dial tone.

Are these VG224s all running the exact same version of IOS ?

GTG

Please rate all helpful posts.
850
Views
0
Helpful
4
Replies
CreatePlease to create content