Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

No dial-tone provided in two-stage dialing scenario

A customer has asked me to setup toll-bypass with no authentication. For some reason when the call is sent to the outgoing pots dial-peer, its sends call out PRI instead of presented dial-tone and allowing caller to enter desired digits.

Called number 0402222 comes in over the wan to gateway and matches below incoming voip dial-peer

dial-peer voice 20 voip

description INCOMING DIAL PEER

incoming called-number .

dtmf-relay h245-alphanumeric

no vad

!

And it matches outgoing POTS dial-peer below

dial-peer voice 10 pots

destination-pattern 0402222

port 0/0/0:23

Debug ISDN q932 reveals calls is sent to telco (no called number obviosly) and call fails. What I want is when it hits this outgoing dial-peer, dial-tone is presented to caller and they can enter digits and then be sent out PRI.

Any ideas on what can be wrong? Why call is sent out PRI instead of dialtone?

Thanks in advance,

2 REPLIES
Community Member

Re: No dial-tone provided in two-stage dialing scenario

Has Cisco remove the security hole so now even if you don't have direct-inward-dial statement on POTS dial-peer, you can't get secondary dial-tone?

Re: No dial-tone provided in two-stage dialing scenario

try to add another dial-peer in addition to what u have

dial-peer voice 11 pots

incoming called-number .

direct-inward-dial

port 0/0/0:23

OR do the fowlloing

dial-peer voice 12 pots

answer-address .T

port 0/0/0:23

143
Views
0
Helpful
2
Replies
CreatePlease to create content