Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

No Dial Tone with SRST

We have an office that uses another offices voice gateway for SRST. I am testing the failover to SRST by null routing the current call managers at our Chicago site. The phones in our Chicago office should then use the SRST function out of our SanFran voice gateway. Our Chicago phones are set up as SanFran phones. My issue is that once I null route, I can see the phones re-registering to voice gateway in SanFran (instead of our normal call managers), but I get no dial tone. Also, no extension shows on the phones. It does say on the phone that the phone is using SRST (forget the exact message).

My question is, does the voice gateway itself have to lose connectivity to the call managers for SRST to work? Is there anything else that I can look at? I know this works since we have failed our SanFran phones before, but we failed the connectivity to our other Call Managers. Thanks in advance.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Red

Re: No Dial Tone with SRST

Hi there,

The Gateway/Router itself (in SanFran) would need to sense the

WAN failure before kicking into SRST mode   This is shown in

these docs;

This describes the process:

http://www.cisco.com/en/US/products/sw/voicesw/ps2169/products_configuration_guide_chapter09186a00806674d2.html#wp1328133

SRST on the gateway.

http://www.cisco.com/en/US/products/sw/voicesw/ps2169/products_configuration_guide_chapter09186a00806674c3.html#wp1351962

Cheers!

Rob

2 REPLIES
Hall of Fame Super Red

Re: No Dial Tone with SRST

Hi there,

The Gateway/Router itself (in SanFran) would need to sense the

WAN failure before kicking into SRST mode   This is shown in

these docs;

This describes the process:

http://www.cisco.com/en/US/products/sw/voicesw/ps2169/products_configuration_guide_chapter09186a00806674d2.html#wp1328133

SRST on the gateway.

http://www.cisco.com/en/US/products/sw/voicesw/ps2169/products_configuration_guide_chapter09186a00806674c3.html#wp1351962

Cheers!

Rob

New Member

Re: No Dial Tone with SRST

That's what I thought. Thanks for the verification!

863
Views
0
Helpful
2
Replies
CreatePlease login to create content