Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

No Directory number assigned for IP communicator in CME

I am using Cisco 2821 router Version 12.4(21), RELEASE SOFTWARE (fc1) as CME.When new IP communicator is registered with CME,no number is assigned but existing one is working without any problem even after reboot.

Is it any limitation on ephone or ephone-dn ? or any resource limitation issue ?

5 REPLIES
Hall of Fame Super Gold

Re: No Directory number assigned for IP communicator in CME

Likely it's not configured correctly.

Re: No Directory number assigned for IP communicator in CME

Try this:

term mon

Then register your CIPC that doesn't work. It will indicate that a particular ephone number has registered.

Likely, you do not have a DN configured under that ephone. This could have happened if you mis-typed or misconfigured the MAC address.

Just find the ephone number it is regstering as, and add the dns to it.

-nick

New Member

Re: No Directory number assigned for IP communicator in CME

I am trying to auto register a fresh IP communicator which the mac address is not configured already.

when a fresh IP communcator is trying to register,the event shows the ephone number.but if we login and look into that ephone number,there is no mac address.I need to add the mac-address manually to make it work.

Re: No Directory number assigned for IP communicator in CME

Use 'show ephone register' to find the MAC, and you should be good to go.

-nick

Hall of Fame Super Gold

Re: No Directory number assigned for IP communicator in CME

Phone may be unregistered if no auto-reg-ephone.

200
Views
0
Helpful
5
Replies