Hi all im stuck and would appreciate your help on this please.
I recently moved and finally got around to setting up my routers a 857 used as a dum modem and my voice 1751 used for everything else.
i had it setup in my other place everything was working perfect -- now i had to get a new number so i figured ok ill change the number no big deal.... well not really now i can make out going calls fine but when i try to get people to dial in all i get is three fast beep beep beeps ????
i checked for possible causes around the forums and the net but have not found anything as such i looked at my incoming dial peers, but why would they have stoped working.... made the changes to the phone numbers but for now i cannot get people to dial in and the debug show NO activity when i dial in?
Thanks, so we have the matching dial-peer but is the Telco sending full number i.e. including the Ireland Country code +353 or it's sending just few digits ( i.e. in case of DID ). Did you verify that with Telco or any debugs ?
If the Telco is sending just few digits, a dial-peer needs to be in place to match them.
Here is the responce that I received from the SIP provider...
Due to legislation in Ireland the number have to be manually linked and validated before the number will start working. We have chased the prosgress of this up and it has now been linked. The number should start working shortly.
they couldnt tell me this before??? only spent all sunday trying to figure out what the issues would of been.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.