Previously I can see ip address of H323 Gateway on CUCM and I can ping from both side. But when I add more dial-peer and route pattern point to that H323. I found that it cannot make call from both side anymore.
So I try to reset h323 gateway on call manager but after reset I found that no ip address show anymore.
I try to reload router and it doesn't work.
I try to do many on H323 Gateway And it still not work.
No IP address show on H323 Gateway on Call Manager
First of all upgrade your IOS as 12.2 is several years old, go to one of the 15.1 trains i.e. 15.1.4M or at least 12.4 train (latest mainline or T release). Then please provide configuration of your router and screen shot of the GW config in CUCM.
Make sure H323 is bound to an interface you are pining from and to.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...