Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

No mgcp/mgcp

I have a 2811 at another location where they are getting fast busy signals.  in the past our engineer would enter a no mgcp/mgcp command to reset the gateway or something and it would correct the problem.  he left the company and left instructions to do this if it happens again.  Well it happend again but when i go into EN mode I get an invalid marker at no mGcp.

has this command changed or is there something that i am missing?

thank you,                 

3 REPLIES
Cisco Employee

No mgcp/mgcp

No, that's the correct command, are you sure you're running MGCP on the router?

HTH

java

if this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Re:No mgcp/mgcp

that what he said and says that was the fix he would do.

if I do a show mgcp I get information back.

Sent from Cisco Technical Support Android App

New Member

Re: No mgcp/mgcp

You have to be in global configuration mode.

  • Stop the MGCP service.

      RTR(config)#no mgcp

  • Verify that the MGCP service is stopped.

          RTR#sh mgcp | i Admin

      MGCP Admin State DOWN, Oper State DOWN - Cause Code NONE

  • Restart the MGCP service with the following command:

         RTR(config)#mgcp

  • Verify that the MGCP service is active.

         RTR#sh mgcp | i Admin

      MGCP Admin State ACTIVE, Oper State ACTIVE - Cause Code NONE

105
Views
0
Helpful
3
Replies