I have a PVDM2-12DM along with a NM-1CE1T1-PRI. I'm running (C2800NM-ENTSERVICESK9-M), Version 12.4(3g. The Modem Country command is not available in this IOS. I assume the modem country command is mandatory. Do I need to be running a different IOS (hopefully not AES)???
The DM module requires a minimum of either 12.4T or 12.4XW and it is depending on your PSTN hardware interface. You can also set country codes using the Cisco IOS modem country command. For more information, see the Cisco IOS configuration guides and command references. The modem country command takes effect immediately, but all active calls are dropped.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...