I have an issue that I need to sort on a network I have to finish by next week. The network consists of FXS's phones on 5x1861 service routers and 3xVG224's connected to two gateways "Nortel Meridian OPT11's".The problem I have is if I dial a number not in the cisco dial plan of dial off switch through the Meridians to a non configured number all I get is a busy tone as if the end user was on the phone!
I need to get the number-unobtainable tone to generate if this happens, if I don't the users will keep dialling the wrong number and eventually call the help desk to report a fault that dose not exist!
Apart from that the network is up and running fine, calls are possessed etc,etc.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...