Following the instructions for the initial setup of a UC520 with ISDN-PRI with 12 PSTN trunks, and only incoming calls on the PRI works. Our current analog number does not ring in on the UC520, and our telephone provider advised that its ported as our pilot number.
Question is: where do I go from here?
Does having no Data WLAN setup affect this? (Our server assigns the data ip addresses)
Should I set it up as a Key System Configuration instead of a PBX?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...