Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

no Q921 or Q931 result on outgoing calls

I have customer which I installed about a month ago. It is a SRST site hanging of a Callmanager 5.1 cluster. We had some issue getting them working, but it was running fine since then, untill now. they have 3 bri interfaces. it does not matter if I configure it for H323 or MGCP, I only get incoming debugs. Nothing outgoing. It is as if the calls never even reach the Gateway. This is the same for q931 and Q921. An ideas?

1 REPLY
Hall of Fame Super Gold

Re: no Q921 or Q931 result on outgoing calls

Are these lines in hunt? Have you set isdn static-tei 0 ?

111
Views
0
Helpful
1
Replies