Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

No user defined country code in CME

Dear Colleagues,

I tried to implement hungarian locale onto our CME, with no success, I am working based on this guide: http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmelocal.html

Unfortunately there is no user defined (U1-U5) option in the user-locale command, only the predefined ones (AT-US)

What am I missed?

Thanks,

Laszlo

Everyone's tags (2)
1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

No user defined country code in CME

Make sure you have configured "cnf-file perphone" and "cnf-file location flash:" under "telephony-service". After configuring these commands you should get U1-U5 option.

Regards,

Mohit Singh

3 REPLIES

No user defined country code in CME

Hi Laszlo,

Please refer below Localization matrix and see if you are meeting the requirement or not.

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/requirements/guide/cmelocal.htm

Regards,
Nishant Savalia

Regards, Nishant Savalia
Bronze

No user defined country code in CME

Make sure you have configured "cnf-file perphone" and "cnf-file location flash:" under "telephony-service". After configuring these commands you should get U1-U5 option.

Regards,

Mohit Singh

New Member

No user defined country code in CME

Hi Mohit,

The cnf-file location flash command was the key... somehow I missed it.

Thanks,

Laszlo

163
Views
0
Helpful
3
Replies