Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

No voice Port after configuring BRI interface NM-4B-S/T

I have this module:NM-4B-S/T

I tried to configure it like this but I am not able to get voice port so I can make dial-peer.

I added the following configuration but no result:

interface BRI1/0

no ip address

encapsulation hdlc

isdn switch-type basic-net3

isdn point-to-point-setup

isdn incoming-voice modem

any help

2 REPLIES
Hall of Fame Super Red

Re: No voice Port after configuring BRI interface NM-4B-S/T

Hi Madi,

Sadly the NM-4B-S/T does "not" support voice.

Voice Hardware Compatibility Matrix (Cisco 17/26/28/36/37/38xx, VG200, Catalyst 4500/4000, Catalyst 6xxx)

http://www.cisco.com/en/US/products/hw/routers/ps259/products_tech_note09186a00800e73f6.shtml

http://www.cisco.com/en/US/prod/collateral/routers/ps5854/ps5882/product_data_sheet0900aecd8016fa68_ps5854_Products_Data_Sheet.html

Hope this helps!

Rob

Re: No voice Port after configuring BRI interface NM-4B-S/T

Sorry to be the bearer of bad news but the NM-4B-S/T is a data only module and does not support voice termination.

264
Views
5
Helpful
2
Replies
CreatePlease to create content