Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Nokia E55 no button

Hi to all,

I have a UC520 with last IOS with CME 7.0  version, try to configure a Nokia E55 as internal device using Nokia CC Cisco, in UC520 I configure aephone like this:

!
telephony-service

load 7970 SCCP70.8-5-3S

ephone  11
device-security-mode none
description Nokia E55
mac-address XXXX.XXXX.XXXX

after-hours exempt
username "user" password user
codec g729r8
type 7970
button  1:10
!

all seem works fine, the registrer regular, but CME does not assign the button, so is then is not possible to use the device, because there not a line assigned.

UC520#sh ephone reg | begin ephone-11
ephone-11[10] Mac:XXXX.XXXX.XXXX TCP socket:[9] activeLine:0 REGISTERED in SCCP ver 5/5
mediaActive:0 offhook:0 ringing:0 reset:0 reset_sent:0 paging 0 debug:0 caps:3
IP:192.168.10.16 44362 Unknown 376  keepalive 2 max_line 0
Preferred Codec: g729
Username: user Password: user
after-hour exempt

Any body have any idea or suggestion? Why it occurs?

Than you very much.

Augusto

1 REPLY
New Member

Re: Nokia E55 no button

Hello Augusto!

Which version of Nokia CC Cisco you are using? v1.1 or v2.0?

Pavel

173
Views
0
Helpful
1
Replies