Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Non-Cisco IP Phone (Nortel) on CCM 4.2(3)

Hello,

I have a question in regards to registering a Nortel phone (1140E) with CCM v4.2(3). I haven't been able to find any information on doing this (in the 4.2(3) CCM Administration Guide) or in this forum...

Is this possible? And if so, is a SIP trunk or Call Manager Express required?

Thanks!

Billy Mathis

3 REPLIES
Hall of Fame Super Silver

Re: Non-Cisco IP Phone (Nortel) on CCM 4.2(3)

SIP Endpoints are not supported in CM 4.X track, you will need 5.X/6.X, or CME 3.4+.

However, I am not sure if Nortel SIP endpoint will work :-(

Chris

New Member

Re: Non-Cisco IP Phone (Nortel) on CCM 4.2(3)

Thanks for the fast reply Chris...much appreciated!

Regards,

Billy

New Member

Re: Non-Cisco IP Phone (Nortel) on CCM 4.2(3)

Is this Nortel phone a SIP device or a Nortel proprietary Unistim device. Many of the early Nortel where the later and they will only work with Nortel's own softswitch CS2K

253
Views
0
Helpful
3
Replies
CreatePlease to create content