Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Bronze

Nortel to Unity via SIP trunk = no DTMF

Hey Everyone,

I have a functioning integration between CUCM 8.6 and a Nortel CS2100 over a SIP trunk.

Basic flow is like this:

CS2100 --- SIP TRUNK --- CUBE --- CUCM 8.6 + Unity Connection

We had to configure various outbound dial-peers so that when dialing anything on the Nortel side from a Cisco phone DTMF was processed and this works great. Here is an example:

dial-peer voice 12345 voip

description calls to XXXXX

destination-pattern 12345

session protocol sipv2

session target ipv4:1.1.1.1

incoming called-number 12345

dtmf-relay rtp-nte

codec g711ulaw

no vad

So basically dialing 12345 from a Cisco phone routes it to the session target which is an Auto-Attendant on the Nortel from there I can enter DTMF without issue.

Now I have a scenario were I am integrating Nortel phones into Unity and the first step is get the same call flow going the other way so my question is can I do an inbound dial-peer through the CUBE for DTMF normalization and make the session target Unity?

5 REPLIES
Silver

Nortel to Unity via SIP trunk = no DTMF

On a CUBE/IOS gateway, each call uses two dial-peers, one for the incoming call leg and one for the outgoing call leg. You can figure out which dial-peer is used for the incoming call leg using the 'debug voip ccapi inout' debug. If you don't already have one matching then create a new incoming dial-peer. Here's a sample incoming dial-peer:

dial-peer voice 1 voip

description Incoming Dial Peer from SIP Server

session protocol sipv2

incoming called-number .

voice-class codec 1 OR codec g729r8 OR codec g711ulaw

dtmf-relay rtp-nte

If the called number are coming in with a specific prefix like an 8 then change the incoming called number to 8.

---

Posted by WebUser Asad Raza from Cisco Support Community App

Silver

Nortel to Unity via SIP trunk = no DTMF

Then you will need an outgoing dial-peer pointing to Unity

---

Posted by WebUser Asad Raza from Cisco Support Community App

Bronze

Nortel to Unity via SIP trunk = no DTMF

Hi,

That makes sense so this is the inbound DP i created , does it look right?

dial-peer voice 12345 voip

description Inbound test

session protocol sipv2

incoming called-number 12345

dtmf-relay rtp-nte

codec g711ulaw

no vad

New Member

Re: Nortel to Unity via SIP trunk = no DTMF

Don't forget your session target.

Sent from Cisco Technical Support iPad App

Silver

Nortel to Unity via SIP trunk = no DTMF

@westa@chop.edu

Yes this looks perfect. You don't need a session target for the incoming dial-peer.

---

Posted by WebUser Asad Raza from Cisco Support Community App

336
Views
0
Helpful
5
Replies
CreatePlease login to create content