Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NOT ABLE TO FIND Dial peers and gateway commands

Hi all,

 

I have 2951 router with "C2951-universalK9-mz-SPA.152-4.M3.bin" ios , my problem is that when I try to configure diap peers i am not seeing these command under "conf ter" , so any one have ide what is the probelem, please help me out for this issue.

I  hope i will receive solution with details .

 

 

Thanks

Rizwan

 

9 REPLIES

Hi Rizwan, If you run a "show

Hi Rizwan,

 

If you run a "show version"  command. Can you see the UC license installed on your router?

 

HTH

Please rate helpful answers

 

Gabriel

New Member

hi Gabriel, Thanks for reply

hi Gabriel,

 

Thanks for reply , yes I am seening these info

License Info:

License UDI:
         
-------------------------------------------------
Device#   PID                   SN
-------------------------------------------------
*0        CISCO2951/K9          FTX1545A0QW   

 

Technology Package License Information for Module:'c2951'

-----------------------------------------------------------------
Technology    Technology-package           Technology-package
              Current       Type           Next reboot 
------------------------------------------------------------------
ipbase        ipbasek9      Permanent      ipbasek9
security      None          None           None
uc            None          None           None
data          None          None           None

Configuration register is 0x2102

Cisco Employee

You don't have a UC license

You don't have a UC license in order to configure voice related commands, you need to buy the license, install it, and then, you can configure DPs.

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
VIP Purple

Hi Rizwan, as rightly

Hi Rizwan,

 

as rightly mentioned by Jaime, u do not have Unified communications /UC license [+5].

you can generate en evaluation license and try the commands.At same time , go for permanent license.

 

regds,

aman

Bronze

Hi Rizwan,To activate the 60

Hi Rizwan,

To activate the 60-day evaluation license enter:

1. configure terminal

2. license accept end user agreement

you will find more details here:

http://www.cisco.com/c/en/us/td/docs/routers/access/sw_activation/SA_on_ISR.html#wp1155517

New Member

thanks bro ,yes u r write ,

thanks bro ,yes u r write , thanks for response I have solve this issue as per ur advice

New Member

thanks bro , yes u r write ,

thanks bro , yes u r write , thanks for response I have solve this issue as per ur advice

New Member

yes u r write , thanks for

yes u r write , thanks for response I have solve this issue as per ur advice

New Member

thanks bro , yes u r write ,

thanks bro , yes u r write , thanks for response I have solve this issue as per ur advice

181
Views
25
Helpful
9
Replies
CreatePlease to create content