We have now 12 channels but the problem is that we need 16 channels, but when I tried to configure it a message appears saying that we have no enough DSP memory. I tried to remove the ds0-group 0 to configure 16 timeslots but I can not. I have installed a PDVM32 but the problem is still the same...
This is the config in my router:
controller E1 3/0/0
ds0-group 0 timeslots 1-12 type e&m-wink-start
description INTERCONNECT | 12 channels to PBX SIEMENS
If you move the T1 card to one of the HWIC slots on the chassis instead of the NM-HDV card, this will work because you have 2 PVDM2-32s on the motherboard. The NM-HDV only has capability for 12 channels at the moment.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.