Null ID in show call history voice brief with UCM 8.6
I found that my gateways in show call active/history voice output shows "0" ID when I call from UCM. This happens on c5350-is-mz.124-3c and c2801-adventerprisek9_ivs-mz.124-24.T1 IOS when I call over SIP trunk. When the call originated from another devices the ID is correct. This is the example:
0 : 5441 1574008280ms.1 +500 pid:0 Answer 1001 active
dur 00:00:01 tx:66/1973 rx:86/1720
IP 10.1.12.126:26708 SRTP: off rtt:0ms pl:0/0ms lost:0/0/0 delay:0/0/0ms g729r8
media inactive detected:n media contrl rcvd:n/a timestamp:n/a
0 : 5442 1574008360ms.1 +420 pid:1000 Originate 2222222 active
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.