I have extn numbers 000-098 assigned to internal users. Requirement was: If anyone presses 0 in the IP phone it should ring the reception number is which is 099. I created num-exp 0 099-it is working. The only problem is: after this command i am unable to reach any other internal extensions having extn no 001, 002,003 etc...Kindly sugegst.
That's because you created an overlap, you could try other methods, i.e. dial-peer, alias, etc but you will always run into overlaps and issues with inter-digit timeout, my recommendation would be to either use something different completely for operator dialing, or something like 0# in which case you will need to map termination digit to something other than #.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...