Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Silver

Number of CSS's

In a centralized standard corporate model how many CSS's are typically used per site, and how many partitions per-site?

is there any particular rule or naming convention one should be following?

tia

Ajaz

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Red

Re: Number of CSS's

Hi Ajaz,

I'm not sure that there is a typical number of CSS's as this depends on the requirements and level of restrictions one may need. There are some really thoughtful "Best Practice" design ideas below;

"Use concise and descriptive names for your partitions. The CompanynameLocationCalltype format usually provides a sufficient level of detail and is short enough to enable you to quickly and easily identify a partition. For example, CiscoDallasMetroPT identifies a partition for toll-free, inter-local access and transport area (LATA) calls from the Cisco office in Dallas."

And for CSS;

The CompanynameLocationCalltype format usually provides a sufficient level of detail and is short enough to enable you to quickly and easily identify a calling search space. For example, CiscoDallasMetroCS identifies a calling search space for toll-free, inter-local access and transport area (LATA) calls from the Cisco office in Dallas.

From this doc;

Partition Configuration Settings

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a0080181a46.html#26766

There are some nice ideas in this doc;

Understanding and Using Partitions and Calling Search Spaces with Cisco CallManager

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a0080094b53.shtml

And this interactive link;

Voice Dial Plan Interactive Voice Network Configuration Example

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a00807f54af.shtml

Hope this helps!

Rob

3 REPLIES
Hall of Fame Super Red

Re: Number of CSS's

Hi Ajaz,

I'm not sure that there is a typical number of CSS's as this depends on the requirements and level of restrictions one may need. There are some really thoughtful "Best Practice" design ideas below;

"Use concise and descriptive names for your partitions. The CompanynameLocationCalltype format usually provides a sufficient level of detail and is short enough to enable you to quickly and easily identify a partition. For example, CiscoDallasMetroPT identifies a partition for toll-free, inter-local access and transport area (LATA) calls from the Cisco office in Dallas."

And for CSS;

The CompanynameLocationCalltype format usually provides a sufficient level of detail and is short enough to enable you to quickly and easily identify a calling search space. For example, CiscoDallasMetroCS identifies a calling search space for toll-free, inter-local access and transport area (LATA) calls from the Cisco office in Dallas.

From this doc;

Partition Configuration Settings

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a0080181a46.html#26766

There are some nice ideas in this doc;

Understanding and Using Partitions and Calling Search Spaces with Cisco CallManager

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a0080094b53.shtml

And this interactive link;

Voice Dial Plan Interactive Voice Network Configuration Example

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a00807f54af.shtml

Hope this helps!

Rob

Silver

Re: Number of CSS's

Really appreciate that.

Ajaz

Hall of Fame Super Red

Re: Number of CSS's

Hi Ajaz,

You are most welcome my friend :)

Take care,

Rob

107
Views
5
Helpful
3
Replies
CreatePlease to create content