Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

Number Restricted

hello  everyone

How to set up a few branches when  connecting to other internal extensions do not appear on the screen of  the number receiving the call?
Can I put  limited number or another number for anyone to call back


any help will be appreciated

Cheers Bruno Rangel Please remember to rate helpful responses using the stars bellow and identify helpful or correct answers .
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Number Restricted

Then your configuration is wrong at some place, the procedure outlined does work

Original DN cannot reach destination DN via CSS

Original DN reaches TP which blocks ANI.

TP CSS reaches destination TP.

Most likely your error is in CSS and partitions, review your configuration.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
4 REPLIES
Cisco Employee

Re: Number Restricted

I'll assume this is CUCM so read this:

Call Display Restrictions

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk
HTH

java

if this helps, please rate

www.cisco.com/go/pdi

Re: Number Restricted

I read  and any questions I post

Thanks

Cheers Bruno Rangel Please remember to rate helpful responses using the stars bellow and identify helpful or correct answers .

Re: Number Restricted

I followed the  procedures but did not work
I created the CSS  and the Partition restricted. Configured not to  display the extension number on the screen.
This  partition must access all branches but the other branches belonging to  domestic participants can not call these extensions.

Cheers Bruno Rangel Please remember to rate helpful responses using the stars bellow and identify helpful or correct answers .
Cisco Employee

Re: Number Restricted

Then your configuration is wrong at some place, the procedure outlined does work

Original DN cannot reach destination DN via CSS

Original DN reaches TP which blocks ANI.

TP CSS reaches destination TP.

Most likely your error is in CSS and partitions, review your configuration.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
176
Views
0
Helpful
4
Replies
CreatePlease to create content