Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

js
New Member

Offramp Gateway to place a call(VXML)

Hello,

I recently configured Offramp Gateway to place a call and activate a VXML script when the called party answers. I use the Cisco NetWorks ESMTP server to trigger a call using the following settings:

EHLO CMUC01.com
mail From: "Grant" <76572xxxx@cmuc01.com>
rcpt To: VXML=006xxxxxxxx@cmuc01.com
data
Trigger

.

Each time I leave the mail from settings blank or enter a invalid phonenumber, the call goes out with our main telephonenumber. Totally normal.If I use the phonenumber currently configured, the call goes out as 76572xxxx and is also displayed on the called phone.

Now my question is, is there a way to block the caller id when a person is called using this trigger?

Thanks in advance,

~Grant

3 REPLIES
js
New Member

Re: Offramp Gateway to place a call(VXML)

Anyone have an idea?

Sorry if I'm a bit impatient, but I have to configure this before tuesday and I have no idea how to.

I tried with Voice translation rules. Enabling caller id block on ephone-dn and putting the dn from that ephone into the mail from. No result.

New Member

Re: Offramp Gateway to place a call(VXML)

What vxml tag / command are you using to initiate the outdial?  There are parameters that can be set to modify the ani digits.  Look for "cisco-aniexpr"

js
New Member

Re: Offramp Gateway to place a call(VXML)

We use a .js script that initiates the dialout trigger.

The script does the same thing as below, but in a script format:

EHLO CMUC01.com
mail From: "Grant" <76572xxxx@cmuc01.com>
rcpt To: VXML=006xxxxxxxx@cmuc01.com
data
Trigger

.

I tried the caller-id block code and set it to *10. But it's not allowed to put *10 into the rcpt to: VXML=............... I get a error message.

Is there any way  to do this by configuring the router itself, instead of the VXML or .js script?

217
Views
0
Helpful
3
Replies