Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

One DN - Rings three phones??

Hello

This is probably the most basic question on earth but I am still getting my head around the CME config and how things work, I am from a R&S/Wireless background.

Ok so I have three dual line directory numbers.

ephone-dn 1 dual-line

number 222 no reg primary

name Office 1

ephone-dn 2 dual-line

number 222 no reg primary

name Office 2

ephone-dn 3 dual-line

number 333 no reg primary

name Office 3

Each of these is assigned to button one of an Ephone:

ephone 1

mac-address xxxx.xxxx.xxxx

type 6941

button 1:1

ephone 2

mac-address xxxx.xxxx.xxxx

type 6941

button 1:2

ephone 3

mac-address xxxx.xxxx.xxxx

type 6941

button 1:3

Effectively I want to be able to dial 111 (i.e DN 1) and it also ring Ephones 2 and 3.

I still need Ephones 2 and 3 to have thier primary numbers as setup, I just need them to also ring if someone dials 111.

Someone put me out of my misery and tell me how basic this is to do?!?

Thanks

2 REPLIES

Re: One DN - Rings three phones??

Hi,

you can have one shared ephone-dn on multiple ephones.

For instance:

ephone-dn 1 dual

name Shared

number 777

ephone-dn 2 dual

name Primary1

number 111

ephone-dn 3 dual

name Primary2

number 222

ephone 1

mac dead:beef:0001

button 1:2 2:1

ephone 2

mac dead:beef:0002

button 1:3 2:1

Alternatively, you can use overlays.

button 1o2,1

if you don't want to use a second button for the shared line.

Take a look at

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmeadm.html

page 915, section "Shared Line Overlays"

G.

One DN - Rings three phones??

Hi

I had a feeling it was very simple.

I just added Directory number 1 (which should be 111 in the original post) as a second button on each of the other two phones. When someone dialed 111, it rang the phone which has the DN on Button 1 and also the other two which had the same DN on button 2.

I was trying to overcomplicate it and it ended up being too simple!!

Thanks for your help

110
Views
0
Helpful
2
Replies
CreatePlease to create content