Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

One pri for voice and data

Customer has VWIC-1MFT-T1 in router 28xx or 38xx and currently T1 is configured as PRI for voice. They would like to use 4 channels from this PRI for data and the rest are for voice. is this supported? Thanks

3 REPLIES
Gold

Re: One pri for voice and data

AFAIK, this cannot be done with one T1. You will need 2 T1s for this. This not only depends on the Router/T1 card, but even on the Provider. Does the Provider support this configuration ??

New Member

Re: One pri for voice and data

I think I saw the following commands before. But couldn't find a link anymore

controller T1 2/1

channel-group 10 timeslots 1-4 (data)

pri-group time slots 5-24 (voice)

Hall of Fame Super Gold

Re: One pri for voice and data

This is possible with recent IOS:

http://cisco.com/en/US/products/ps6706/products_feature_guide09186a00805fe293.html

You only configure PRI, no channel-group. The documentation describes the feature available for call preemption.

Hope this helps,please rate post if it does!

118
Views
0
Helpful
3
Replies