We have one way audio issue. When I Receive/Make a call from the IP phone nobody can hear me but I can hear the other end very well. I know most of the time this is an routing misconfiguration but I don't seem to be able to figure out where the problem is. Any help would be greately appreciated. I am uploading the config for Switch where the phone is contected and the GW contected to the PSTN.
GateWay (C3845-SPSERVICESK9-M), Version 12.4(15)T1
Access Switch (C3750-IPBASEK9-M), Version 12.2(25)SEE2
I double checked there's no issue with the IP conectivity. You just repeated the config that I had posted in your reply but you don't say if there's anything wrong with it. Is there anything wrong with the interfaces and the mgcp bind config?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...