I've configured MGCP on a 2801 with a VIC2-2FXO card and configured the gateway on CCM. It registers and all looks good. I can call fine between my IP phones but when I try to call out to the PSTN through the FXO port I end up with one way audio.
Specifically I can hear the audio from the PSTN phone but they can not hear me.
I tried running "debug mgcp packets" and noticed that during call setup I see the following...
000203: May 28 12:11:33.703: MGCP Packet received from 10.20.4.52:2427--->
The item which concerns me is the "Connection Mode" paramater ser to "Read Only" which apparently means the the connection is being put in a one-way audio state of recieve only. Can anyone tell me why this might be and what I need to do to get normal two way audio?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...