I was wondering if anyone has every had this issue and what might be the cause. I have 2 analog circuits setup for 911 and local calling on a 2821 router. The local calling is only for testing in this case.
I have set my cell number as a route pattern and directed it to a route-list which first includes this 2851(to pots lines) and then a cisco CUBE with a SIP trunk.
What happens is when I pull out the analog ports on the 2851 and I try to make a call to my cell from a cisco phone the call completes but I only get one way audio. They can hear me on my cell but I can't hear from them(ip phone). When I unplug the 2851 from the network the call completes and there is two way audio. I think the issue here is the 2851 because everything works when it is out of the picture. I'am running code c2800nm-spservicesk9-mz.124-20.T2.bin.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...