Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Oneside voice issue through VPN for PSTN calls

We are using CUCM 8.x and MGCP gateway 3925. After migrating MPLS link from one SP to another we are facing one side voice issue when users call from soft phone or CUPC when they connect through VPN. Soft phone users can hear PSTN user but PSTN caller not able to hear Softphone users. Users able to hear each other when they call internal extensions even though connected through VPN. Anyway call setup is working fine and user able to hear the ring back tone also. But when call answers ther is only one side voice. We are not sure what happened after link migration. Is it a firewall issue ? somebody can help us on this. Thank you

4 REPLIES
New Member

Oneside voice issue through VPN for PSTN calls

Did u properly configure DSP resources and did u configure codec??? Paste your gateway config.

Rate if post helpful

Cisco Employee

Oneside voice issue through VPN for PSTN calls

I doubt its a codec issue as the call wouldnt complete. Normally one way audio issues are routing issues.

The very fact that Softphone is able to hear PSTN and vice versa doesnt work prompts me to sniff the egress interface of the router (interface where you have bound yr media traffic) and see if there is a increment with source being the ip add of the cups/cipc.

what changed between yr first and second provider, like ip add, ports etc..

i still think its a network / firewall traffic issue.

New Member

Oneside voice issue through VPN for PSTN calls

Hi,

Please go through the below link and check for configuration for softphone

http://www.cisco.com/en/US/products/sw/voicesw/ps1860/products_tech_note09186a0080094ed1.shtml

Regards,

Baskaran.M

Oneside voice issue through VPN for PSTN calls

507
Views
0
Helpful
4
Replies
CreatePlease to create content