Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

only manager must use one of the fxo port

hi,

2851 ccme router, 7961 ip phone for the manager

i asssigned 2 lines for the manager

one for his DID number

and the second line is his analog line(plar works under analog line)and directs the calss his ip phone second line

manager has direct line,and i added plar for outside callers can directly reach the manager if they know his direct number.. But when the manager wants to call from his direct line he can call outside from another fxo line.. is it possible to let him to call from his direct analog line not from the other fxo lines..

output of the sh run

voice-port 0/2/3

timeouts wait-release 3

connection plar opx 99

i got 2 x vic2-4fxo

6 REPLIES
Green

Re: only manager must use one of the fxo port

http://www.cisco.com/en/US/products/sw/voicesw/ps4625/products_command_reference_chapter09186a0080611369.html#wp1094625

Yes, try to use the TRUNK command. under EPHONE-DN

Configuration sample is the link.

HTH

//G

New Member

Re: only manager must use one of the fxo port

hi

it is ok and working

but the problem is if someone from pstn calls this direct line, the callerID seen on the ephone is 801 .config is below

any idea? thanks.

!

voice-port 0/2/3

timeouts wait-release 3

connection plar opx 99

description analogue line

dial-peer voice 801 pots

destination-pattern 801

port 0/2/3

ephone-dn 2

number 99

pickup-group 14

label direkt hat

name test

hold-alert 30 originator

trunk 801 timeout 10

!

ephone 39

ephone-template 1

username manager

type 7960

button 1:73 2:2

Hall of Fame Super Gold

Re: only manager must use one of the fxo port

You see 801 because that is the tagnumber of DP and caller-id is not enabled on that line.

If you do not have caller-id, configure a tagnumber that you like as DP.

Hall of Fame Super Gold

Re: only manager must use one of the fxo port

or else, configure station number under voice port. This will overwrite if no caller-id info is received.

New Member

Re: only manager must use one of the fxo port

ok i changed little bit the config

voice-port 0/2/3

timeouts wait-release 3

connection plar opx 99

description analog line

caller-id enable

ephone-dn 2

number 99

pickup-group 14

label direkt hat

name test

hold-alert 30 originator

trunk 801 timeout 10

dial-peer voice 801 pots

destination-pattern 801

port 0/2/3

ephone 39

ephone-template 1

mac-address 0018.BAF8.B9FE

type 7960

button 1:73 2:2

analog calls come and i can call from my analogue line

but still callerID is missing.

any idea?

thanks

Gokhan

Hall of Fame Super Gold

Re: only manager must use one of the fxo port

Hi, please configure "cptone " under voice-port to enable caller-in the router.

As a courtesy to those providing answers, please rate all useful posts using the scrollbox below!

118
Views
0
Helpful
6
Replies